- POOLFESSIONALS
-
23052 Alicia Pkwy Ste H, #199,
Mission Viejo, CA 92692 - (949) 997-3232
- [email protected]
If you’re expecting storms or heavy rain, it may be wise to lower the water level in your pool proactively to offset what’s to come. Doing so can help mitigate the impact of any excess rain or stormwater that could cause overflow and damage if not properly managed. If there is a lot of rain predicted, you can lower the water level to the bottom of the skimmer. However, do not run your pool pump at this time as it could damage your equipment if it runs dry.
For more information on how best to drain your pool, please refer to the ‘how to drain your pool’ section for specific instructions and options.
Most modern pools are equipped with an overfill drain on the side of the pool, which allows any excess water to be redirected to a deck drain and then out to the street. This is usually sufficient to keep up with normal rainfall; however, if it’s raining heavily or your pool isn’t equipped with an overfill drain, you may need to consider other methods for draining the excess water.
If your yard or deck surrounding the pool has adequate drainage, it should be possible to divert this water to the street. However, if you don’t have deck drains or are compromised in some way, you will need to look into alternative ways of safely and efficiently draining the water. Several options, such as submersible pumps and sump pump systems, can be explored.
We do not recommend that you drain water out of your pool unless:
· You know what you are doing
· You have the time to supervise the whole procedure.
Here are a few additional do’s and don’ts:
· Never leave your pool draining while you leave the premises
· Make sure discharge water is going to an approved location and not flooding a neighbor’s yard or your equipment pad.
· You need to be there to turn off the pump and change the valves when the water gets to the proper level.
· Don’t delegate this to a minor or someone unfamiliar with the pool pump and its valves
· Never operate your pump or the time clock if there is standing water at or above the level of the pump motor
· Never operate any electrical equipment or switch if you are in standing water.
· Leave the system alone or if absolutely necessary turn the system off at the main house breaker inside and wait for groundwater to recede before going out to the pool equipment.
Some filter systems allow you to attach a hose spigot directly to the plumbing; if you’re lucky enough to have this option, you can attach a garden hose to the existing spigot and start draining your pool. To drain water from your pool using an existing hose spigot:
Step 1: Connect a garden hose to the hose spigot at the pool equipment (See photo).
Step 2: Once the hose is connected to the bib at the equipment, run the other end of the hose to an area you want the water to drain to.
Step 3: Make sure the pool pump is running.
Step 4: Open the hose bib, and your pool is draining! You can confirm this by looking at the other end of the hose to make sure water is coming out the other side.
Once your pool is at the desired level, turn the hose bib off. Please keep in mind that this is not a fast method, it may take an hour to get results, but it works.
Be careful not to drain the pool below the skimmer openings; this could result in the pump catching air and burning up the motor.
Backwashing is only available on filter equipment with a backwash valve. We do not recommend performing this as a first resort, nor do we provide instructions for doing so due to the potential risks involved and the complexity of safely performing this process. Backwashing can be an effective and quick way to drain your pool, but if done improperly, it can lead to internal damage to the filter, which could cost hundreds of dollars in repairs. We urge caution when considering backwashing as an option.
Be careful not to drain the pool below the skimmer openings, this could result in the pump catching air and burning up the motor.
This is a last-resort option as it may lead to property damage. You won’t be the first to let the pool overflow, and you may not have any other option. In most cases, the water from the pool will safely find a path out, whether down the side yard, into deck drains, or somewhere else. If flooding is a concern due to poor drainage in your yard, additional measures should be taken to prevent water from entering your home. Be aware of any signs of flooding and take action if necessary. Taking precautionary steps can help mitigate potential damage.
These pumps are a great option for those looking for a quick and easy solution to lower their pool’s water levels. These pumps can be placed directly beneath the water surface and have a garden hose hook-up that allows you to direct the flow away from the pool with high precision. You can purchase these pumps from most hardware stores, such as Home Depot and Lowes, for around $100. However, it is important to note that these pumps should not be used during rain due to the potential electrical safety hazard that this presents.
Note: Be careful not to drain the pool below the skimmer openings, this could result in the pump catching air and burning up the motor.
If you have the time, energy, and equipment to handle an overflowing pool, you can certainly attempt to drain it yourself. However, if that’s not an option for you, our team at Poolfessionals is here to help! It’s important to note that due to the equipment and electricity required for draining pools, we are unable to offer this service while it’s raining. If you have any questions at all regarding our services, please don’t hesitate to contact us! We’re here to help however we can.
If your pool and/or spa equipment area is prone to flooding due to poor drainage or location, it’s important that you turn off the system until the flooded area is drained. This will help prevent costly damage to your equipment. Monitor your equipment area for any signs of water buildup, as this could indicate an impending flood which should be addressed to avoid further damage. Taking proactive steps to address flooding can save you money in the long run.
Its is quite common that you find your filter needing a cleaning following a storm. With all the particulates and debris pools are subjected to during a storm, the filter is the main work horse for getting the water clear again. At the very least you may find your filter needing to be cleaned earlier than normal.
Having murky water following a storm is completely normal. It may take a few days with the system running for the water to appear clear again.
First, the brownish or green hue you see in your pool or spa water following a storm is usually not algae. Rather, it is caused by contaminants from the rainwater and runoff reacting with the sanitizer in your water. Additionally, some organic debris can change your water’s color, like tea darkens water. In most cases, this discoloration should clear itself up within a week of proper circulation and sanitization. However, if the discoloration persists after two weeks, it is advised to replace the water completely.
If your pool has been inundated with dirt due to a storm, you may find yourself in a muddy situation. In some cases, it can take multiple visits and filter cleaning to get the water back to its normal state. However, when there is an extreme amount of dirt present, draining the pool may be necessary to remove the soil and ensure that the water is safe and healthy for swimming. Doing so will restore your pool to its original state, allowing you to enjoy it once more.
After a storm, it is likely your pool will be filled with leaves, branches, and other debris. It is recommended that you check your baskets the day following a storm to ensure the system continues to flow properly. If Poolfessionals provides your weekly maintenance services, please refer to our section below on “Managing Expectations” for more information.
Just because your pool water looks clean after a storm doesn’t mean that its chemistry is correct. Depending on the environment of your pool, its chemistry can be heavily altered by rain and require special chemicals to restore it to balance. In some cases, full water replacement may be necessary. It’s important to keep in mind that rainwater is naturally acidic and can negatively affect water chemistry. Additionally, runoff from your roof, patio, landscaping, etc., can bring in a variety of contaminants that may further impact the pool’s chemistry. Therefore, it’s necessary to take proper steps to restore your pool’s water chemistry after a storm. Regularly test and monitor the water quality and take action if something is out of balance.
Our team takes safety very seriously, and when there are high winds or rain on the day of scheduled maintenance, our number one priority is to ensure the safety of our staff. Though we always strive to reduce the impact on your pool/spa and attempt to carry out all necessary maintenance tasks as usual, in some cases this may not be possible due to the weather conditions. We apologize for any inconvenience this may cause and thank you for your understanding. Rest assured that we will do our best to minimize any disruption caused by the weather.
We kindly ask for your patience as our team works diligently to get all the pools we care for up to their usual standards. This may take a few visits, during which time your pool may not be as clean and pristine as you are used to having it. We greatly appreciate your understanding while we work to make sure your pool is in top condition. If you have any questions or concerns, please don’t hesitate to contact us at 949.997.3232 or [email protected]. Thank you!
A swimming pool is a wonderful addition to any backyard, providing a refreshing escape from the hot summer sun and a perfect place to unwind and relax. However, owning a pool comes with a certain level of responsibility, including regular maintenance to ensure its cleanliness, safety, and proper functioning. This is where weekly pool service comes in.
A weekly pool service is a routine maintenance service provided by pool professionals to ensure that your pool is clean, safe, and running efficiently. This service typically includes a variety of tasks designed to keep your pool in top condition, such as testing and balancing the water chemistry, cleaning the pool and equipment, and inspecting and maintaining the pool’s mechanical components.
One of the most important aspects of weekly pool service is maintaining proper water chemistry. The water in your pool needs to be kept at the right balance of pH, alkalinity, and chlorine levels to ensure a healthy swimming environment. If the water chemistry is not properly balanced, it can cause skin and eye irritation, algae growth, and even damage to the pool equipment.
During a weekly pool service visit, a pool technician will test the water chemistry and adjust the chemical levels as needed. They may also add additional chemicals such as algaecides or clarifiers to help keep the water clear and clean. By keeping the water chemistry in check, you can ensure that your pool is safe and comfortable for swimmers, and avoid potential health hazards.
In addition to maintaining proper water chemistry, a weekly pool service also involves cleaning the pool and equipment. Over time, leaves, debris, and other contaminants can accumulate in the pool, making it unsightly and potentially unsafe for swimmers. During a weekly pool service visit, the technician will skim the surface of the water to remove any debris, brush the sides and bottom of the pool to remove algae and other buildup, and vacuum the pool to remove any remaining dirt and debris.
In addition to cleaning the pool itself, the technician will also clean and maintain the pool equipment, such as the filter and pump. A dirty or clogged filter can reduce the efficiency of the pool’s circulation system, leading to cloudy water and potential damage to the equipment. During a weekly pool service visit, the technician will clean or replace the filter as needed to keep the circulation system running smoothly. They will also inspect other mechanical components, such as the pump and heater, to ensure that they are functioning properly and make any necessary repairs or adjustments.
By having your pool cleaned and maintained regularly, you can extend the life of your pool and its equipment, and avoid costly repairs down the road. Regular maintenance can also help to prevent problems before they occur, such as equipment failure or algae growth, which can be difficult and expensive to fix.
Another benefit of weekly pool service is that it saves you time and effort. Maintaining a pool can be a time-consuming and labor-intensive task, requiring regular cleaning, testing, and maintenance. By enlisting the help of a professional pool service, you can save yourself the time and hassle of maintaining your pool, and spend more time enjoying it instead.
When choosing a weekly pool service, it is important to choose a reputable and reliable company. Look for a company with experienced technicians who are knowledgeable about pool maintenance and repair. They should also be licensed and insured, and provide a satisfaction guarantee for their services.
In addition to regular weekly service, some pool companies also offer additional services such as one-time cleanings, equipment repairs or replacements, and winterization services. These services can help to keep your pool in top condition throughout the year, and ensure that it is ready to go when the swimming season begins again.
In summary, a weekly pool service is an essential part of maintaining a clean, safe, and functional swimming pool. By maintaining proper water chemistry, cleaning the pool and equipment, and inspecting and maintaining